> On Sun, Apr 09, 2000 at 09:11:00PM +0900, suzukis@xxxxxxxxxxxxxxxxxxxxxx wrot
> > >Try turning off CONFIG_KDB or apply the following patch:
> > OK, I will use your patch - I wish your patch will be
> > applied in CVS tree of SGI soon.
> I hope so too (I need it for my AMDs)
> > However, turning off CONFIG_KDB could not save me,
> > because the part was always compiled (there's no
> > "ifdef - endif" conditional scissor in page_fault
> > entry modification).
> Good point. The patch should work though.
> The page_fault entry change obviously was a quick hack that was not
> fully thought out..
Hi, sorry for not getting back to you on this sooner, I tried out the
pacth, and I think there is a problem with the code which determines
the cpu id, it fails to recognize a P3 Katmai, the bootup code reports
CPU0: Intel Pentium III (Katmai) stepping 03
CPU1: Intel Pentium III (Katmai) stepping 03
But the cpuid code in kdb ends up giving me type 3 (unknown). Maybe
it would be better to directly reference the cpuinfo_x86 setup at