After a disk problem (bad sectors) I have the following problem:
Using xfs_repair on the device I receive the following message:
corrupt inode XXXXX (btree). Unmount and run xfs_repair.
fatal error -- 990 - couldn't iget disconnected inode
The device is unmounted at this point and re-running xfs_repair dives the same
output. The resulting fs is mountable, but part of it is not recovered.
Is there a way to "skip" the corrupt inode, so the repair can finish, even
losing some data?
Join Excite! - http://www.excite.com
The most personalized portal on the Web!